Constant Variable Blink Delays

Use the ‘Parts List’ image along with the component cards in your box to correctly plug in the electronic hardware to your Maker Board. The colorful dots next to the legs of the components match up to the ports where that leg should go on Maker Board’s ports.

Code

The code in the editor below is ready to run! Plug in the electronic components just like the Parts List card above, connect Maker Board to your computer's USB port with the cable, and hit 'Upload Your Code!'. Tinker with the code and change something! If you get stuck, you can hit the 'Restore' button to make the code go back to the working example.


/* Replace a blink delay with a variable */ int wait = 1000; //create a variable, named 'wait', with a type of 'int', which means it will be a whole number - no decimals //Variables can be named almost anything. Names can't start with numbers or use other keywords from the code, like 'void' void setup(){ pinMode(2,OUTPUT); //LED } void loop(){ digitalWrite(2,HIGH); //Turn on the LED delay(wait); //delay for an amount of time equal to wait. Here it is 1000 milliseconds (1 second) digitalWrite(2,LOW); //Turn off the LED delay(wait); //delay for 'wait' amount of time } // (c) 2019 Let's Start Coding. License: www.letsstartcoding.com/bsdlicense
 

Walkthrough Video

Watch the video for a line-by-line explanation of how the example program works. Then you'll be ready to make some changes of your own!

Challenges

Can you complete the challenges? Change the code in your code editor above. Upload your code to see the effect when you're finished. Complete a challenge? Check it off the list!

Concepts

These are the new code concepts covered in this example program. To become a great coder, read through these concepts to learn new vocabulary.

Quiz

If you're having trouble, try to run an experimental program or look at the example code to help you find the answer.

1. Which syntax ends the entire 'void loop' function?




2. Which syntax ends a single code command?