6_3 Motor Latch

Motor Latch

Code

The code in the editor below is ready to run! Plug Code Lab Mini in to your computer's USB port with the cable and hit 'Upload Your Code!' to see what it does. Change something in the code, like a delay or pin number. Try to add something new to the program - it's yours to tinker with! You can always press the 'Restore' button to return the code to the working example.

Restore 12 14 18 24 30

Monitor Upload Your Code!

/* Create an on button that switches on the motor pressed, then turns it off when the button is pressed again */ int pressCount = 0; //An integer (whole number) variable to keep track of how many times the button is pressed void setup(){ pinMode(3,OUTPUT); //motor pinMode(4,INPUT_PULLUP); //button } void loop(){ if(digitalRead(4)==LOW){ //if button 4 is pressed pressCount++; //add one to a variable. Now pressCount = its former value + 1 delay(250); //delay to release your finger from the button without counting multiple presses } if(pressCount == 1){ //if pressCount equals 1.. digitalWrite(3,HIGH); //turn on the motor } else{ //if pressCount is anything other than 1... digitalWrite(3,LOW); //turn off the motor pressCount = 0; //reset the count to 0 before the loop starts again } } // (c) 2023 Let's Start Coding. License: www.letsstartcoding.com/bsdlicense

 

It looks like your computer isn't set up to code yet. Setup My Computer

Success!

Compile errors:

Serial port monitor: Input: Send Close

 

Walkthrough Video

Watch the video for a line-by-line explanation of how the example program works. Then you'll be ready to make some changes of your own!

Challenges

Can you complete the challenges? Change the code in your code editor above. Upload your code to see the effect when you're finished. Complete a challenge? Check it off the list!

Make the code turn on an LED along with the motor when the button is pressed.

Change the 'else' statement so that if the button isn't pressed, you analogWrite the motor to vibrate at 1/2 of its total strength.