/*Use a rising variable for the brightness of one of Buzz's LED eyes
Only LED pins 3,5,6, and 9 work with analogWrite on Buzz, so you must use those pins.
*/
int brightness = 0; //Create a variable called 'brightness' that is an integer (whole number) and has a starting value of 40
void setup() {
pinMode(3,OUTPUT); //LED
}
void loop() {
analogWrite(3,brightness); //set the brightness of the LED equal to the variable
brightness++; //Increase the variable by 1
delay(50); // delay 0.05 seconds before the loop starts again.
/*analogWrite has a maximum value of 255, so the code treats 256 like it equals 1,
257 like it equals 2, and so on. The write "overflows" and resets the brightness
*/
}
// (c) 2023 Let's Start Coding. License: www.letsstartcoding.com/bsdlicense
It looks like your computer isn't set up to code yet.
Success!
Compile errors:
Serial port monitor:
Input:
Walkthrough Video
Watch the video for a line-by-line explanation of how the example program works. Then you'll be ready to make some changes of your own!
Challenges
Can you complete the challenges? Change the code in your code editor above. Upload your code to see the effect when you're finished. Complete a challenge? Check it off the list!
Concepts
These are the new code concepts covered in this example program. To become a great coder, read through these concepts to learn new vocabulary.
Quiz
If you're having trouble, try to run an experimental program or look at the example code to help you find the answer.
1. Which syntax ends the entire 'void loop' function?