LED Strip Shadow Counter

Use the ‘Parts List’ image along with the component cards in your box to correctly plug in the electronic hardware to your Maker Board. The colorful dots next to the legs of the components match up to the ports where that leg should go on Maker Board’s ports.

Code

The code in the editor below is ready to run! Plug in the electronic components just like the Parts List card above, connect Maker Board to your computer's USB port with the cable, and hit 'Upload Your Code!'. Tinker with the code and change something! If you get stuck, you can hit the 'Restore' button to make the code go back to the working example.


/* 'Shadow counter' adds one more lit pixel to the LED strip when the light sensor 'sees' darkness */ #include "LEDStrip.h" //The LEDStrip.h library gives your code access to special functions exclusive to the LED Strip LEDStrip strip = LEDStrip(15, 13, 12); //Set up the strip by defining how many pixels (15) and where the wires are connected (green = 13, blue = 12) int pixelCount = 0; //create a variable named pixelCount that is an integer (whole number) with starting value of 0 void setup() { pinMode(A2,INPUT); //light sensor in the smaller block of ports with the + and - ports } void loop() { if(analogRead(A2)< 300){ //if the light reading is lower than 300... pixelCount++; //increase the value of pixelCount by 1 } strip.setPixel(pixelCount,100); //light the number of pixels equal to the pixelCount variable, with a color value of 100 strip.draw(); //send the setPixel data to the strip delay(500); //wait 500 milliseconds (0.5 seconds) between light readings so a single shadow doesn't count more than once if(pixelCount>14){ //if all 15 pixels (0-14) are lit and another shadow makes pixelCount > 14... pixelCount=0; //reset the pixelCount variable to 0 strip.clear(); //clear the lit pixels off the LED strip } //Note: You might need to adjust the 'shadow' threshold depending on how bright or dim your environment is! } // (c) 2019 Let's Start Coding. License: www.letsstartcoding.com/bsdlicense
 

Walkthrough Video

Watch the video for a line-by-line explanation of how the example program works. Then you'll be ready to make some changes of your own!

Use this spectrum to estimate the color values you'll need for your 'setPixel' arguments to achieve your favorite color!

Challenges

Can you complete the challenges? Change the code in your code editor above. Upload your code to see the effect when you're finished. Complete a challenge? Check it off the list!

Concepts

These are the new code concepts covered in this example program. To become a great coder, read through these concepts to learn new vocabulary.

Quiz

If you're having trouble, try to run an experimental program or look at the example code to help you find the answer.

1. Which syntax ends the entire 'void loop' function?




2. Which syntax ends a single code command?