Blink Row of LEDs

Use the ‘Parts List’ image along with the component cards in your box to correctly plug in the electronic hardware to your Maker Board. The colorful dots next to the legs of the components match up to the ports where that leg should go on Maker Board’s ports.

Code

The code in the editor below is ready to run! Plug in the electronic components just like the Parts List card above, connect Maker Board to your computer's USB port with the cable, and hit 'Upload Your Code!'. Tinker with the code and change something! If you get stuck, you can hit the 'Restore' button to make the code go back to the working example.

/* Blink on and off a row of LED lights in sequence */ void setup(){ //combine single color LEDs with an RGB LED to fill all these ports! pinMode(2,OUTPUT); //LED pinMode(3,OUTPUT); //LED pinMode(4,OUTPUT); //LED pinMode(5,OUTPUT); //LED pinMode(6,OUTPUT); //LED pinMode(7,OUTPUT); //LED } void loop(){ /*create a variable named i that has a starting value of 2. Until i equals 7, run the code between the curly braces, then increase the value of the 'i' variable by 1*/ for(int i=2;i<8;i++){ digitalWrite(i,HIGH);//turn on the LED whose port number is equal to 'i' delay(500); //wait 500 milliseconds (0.5 seconds) with the LED on digitalWrite(i,LOW); //turn off the LED whose port number is equal to 'i' delay(500); //wait 500 millisecond (0.5 seconds) with the LED off before running the 'for' loop again } } // (c) 2019 Let's Start Coding. License: www.letsstartcoding.com/bsdlicense

Walkthrough Video

Watch the video for a line-by-line explanation of how the example program works. Then you'll be ready to make some changes of your own!

Challenges

Can you complete the challenges? Change the code in your code editor above. Upload your code to see the effect when you're finished. Complete a challenge? Check it off the list!

Comment out’ the second delay by adding two forward slashes (//) to the left of the word ‘delay’. Before you upload, predict what will happen when you do this.

Change either (or both) delays to a much smaller delay.

Try to add the other RGB (red-green-blue) LED to this circuit and this program. You’ll need 3 more pinMode functions and one small change to the condition of the ‘for’ loop.

Concepts

These are the new code concepts covered in this example program. To become a great coder, read through these concepts to learn new vocabulary.

Quiz

If you're having trouble, try to run an experimental program or look at the example code to help you find the answer.

1. Which syntax ends the entire 'void loop' function?

semicolon ;
parentheses )
closing curly brace }

2. Which syntax ends a single code command?

semicolon ;
closing curly brace }
period .

Back to Projects Grid